When bending an 18-inch offset using 60° bends in 1-inch RMC, what multiplier (rounded to the nearest tenth) would be used to determine the distance between bends?

Question

31-05-2025
Physics

High School

Thank you for visiting When bending an 18 inch offset using 60 bends in 1 inch RMC what multiplier rounded to the nearest tenth would be used to determine. This page is designed to guide you through key points and clear explanations related to the topic at hand. We aim to make your learning experience smooth, insightful, and informative. Dive in and discover the answers you're looking for!

When bending an 18-inch offset using 60° bends in 1-inch RMC, what multiplier (rounded to the nearest tenth) would be used to determine the distance between bends?

Answer :

Other Questions

Food handlers should be especially careful about avoiding bare-hand contact with ready-to-eat

On the circle you created in Question 1, follow these steps: 1.

Determine the molarity of a solution formed by dissolving 97.7 g of

Florida has _______ DUI laws, which means that the penalties get much

Ready-to-eat TCS food prepped in-house must be date marked if it is

Refer to the following table: - GDP: $5.0 trillion - Government purchases:

In the State of Florida, your first conviction for DUI can result

Fundamental analysts tend to think that the market is about ______ logical

Successful fashion forecasters rely on which factor to predict the strength and

What does "imagery" mean? A. The use of drawn or photographic images

A climograph: A. is an imprecise display of data. B. is usually

What should be done to ready-to-eat TCS food that will be prepped

The period of the second hand on a clock is: A) 1

A primary purpose of restoration work on rivers in Northwestern Europe is

Which of the following is NOT a procedure for preventing exposure to

rohitsinghthepla rohitsinghthepla · Answer 1 · 2024-07-26T09:28:35-04:00

Final answer:

To create an 18-inch offset using 60° bends in 1-inch RMC, one would use the standard multiplier for a 60° bend of 1.7 after rounding to the nearest tenth. The distance between bends is calculated by multiplying the offset depth (18 inches) by the multiplier (1.7) resulting in a distance of 30.6 inches between bends.

Explanation:

The question asks about the calculation of the distance between bends when creating an 18-inch offset with 60° bends in 1-inch rigid metal conduit (RMC). To determine this distance, one would use the bending multiplier for a 60° bend. The standard multiplier for a 60° bend is 1.732. However, because we are asked to round to the nearest tenth, we would use 1.7 as the multiplier.

To calculate the distance between bends, you multiply the offset depth by the multiplier. So for an 18-inch offset, the distance between bends would be 18 inches times 1.7, which equals 30.6 inches. Therefore, when bending an 18-inch offset using 60° bends in 1-inch RMC, one would use a distance of 30.6 inches between bends.